Dynalab Test Systems

Dynalab NX Fixture Interfacing

 

 

 

 

Discrete Wire Interface Cable
 
The Discrete Wire Interface Cable is the most commonly used interface cable. Its 64 individual 24 AWG wires are cut to length - ready to be attached to a fixture. This cable interfaces any Dynalab Tester and is available in three lengths.
5-2006......6’ Interface cable assembly
5-2012......12’ Interface cable assembly
5-2018......18’ Interface cable assembly

 

 

 

Discrete Wire Connector
 
To create custom interface cables, Dynalab offers the connector used to build the Discrete Wire Interface Cable.
Note: Special crimping is required to attach wires to this connector.
5-2091......Card Edge Connector

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Terminal Block
 
To aid test fixture building and maintenance, Dynalab offers test point distribution solutions. Ribbon cables neatly deliver test points from the NX Tester to Terminal Block Interfaces. Fixture elements are attached to the Terminal Block Interface by screw terminals. Should a fixture block require maintenance, it can be unscrewed and replaced with a substitute in seconds.

 

Discrete Wire
 
NX Tester Test Point Boards are divided into two sets of 64 points, each designed to mate with a 64 pin card edge connector. Dynalab uses card edge connections, rather than fine pitch, pin-type connectors, for durability and ease of use. A wide range of interface cables are offered to attach a Dynalab NX Tester to your test fixture.

Hipot Fixture Interfacing
 
NX Hipot Test Point Boards are divided into two sets of 32 points, each designed to mate with a 32 pin DIN connector.

Hipot Discrete Wire Interface Cable
 
The Hipot Discrete Wire Interface Cable consists of 32 individual 22 AWG wires are cut to length - ready to be attached to a fixture.
5-2106......Discrete Wire Interface 6’

Hipot Discrete Wire Connector
 
To create custom interface cables, Dynalab offers the connector used to build the Discrete Wire Interface Cable.
5-2093......HIPOT Mating Connector w/ Hood
5-2092......HIPOT Mating Connector w/O Hood

Terminal Block Interface
 
The Terminal Block Interface allows the user to distribute the test points away from the NX Tester and provide an easy to use screw terminal interface. These devices are connected to the NX Tester using the Ribbon Cable Interface Assemblies.
5-2191......Terminal Block Interface

Ribbon Interface Cable
 
The Ribbon Interface Cable is offered for specialized applications where a Dynalab NX Tester must be connected to a printed circuit board or any device containing a dual row header (0.100" spacing). This cable is available in three lengths.
5-2102......Ribbon Interface Cable 2’
5-2104......Ribbon Interface Cable 4’
5-2108......Ribbon Interface Cable 8’

Ribbon Cable Components
 
To create custom ribbon cables, Dynalab offers 64 conductor ribbon cable and two common ribbon cable connectors. Both connectors are insulation displacement.
5-2192......Card Edge Connector
5-2193......Dual Row Header Connector
5-2194......64 Conductor Ribbon Cable (100 foot lengths)